The costs for this repair will be covered during the normal warranty. see working procedure "Cooling system charge and Bleed ", Connect wiring harness connector to engine coolant temperature Lay wiring harness below coolant hose and clip in (Picture VI)ġ7. Remove engine coolant temperature sensor and install new engineġ6. Install cable lug into new wiring harness connectorġ5. Install wiring harness to rill tube and wrap with insulation tapeġ4. Move both shrink hoses over the crimps and heat withġ3. Sensor wiring harness with MKM-923-31 (Picture IV)ġ2. Crimp new wiring harness to engine coolant temperature Move head shrink tube over both cablesġ1.
Remove insulation from engine coolant temperature sensorġ0.
Wiring harness and cut to length (Picture III)ĩ. Compare new wiring harness to engine coolant temperature sensor Bare both cable of wiring harness with MKM-923-31Ĩ. Cut engine coolant sensor wiring harness (Picture II)ħ. Remove insulation tape and cut lengthwise, bare the wiring harnessĥ. (Picture I, 1) and loosen wiring harness from engine coolantĤ. Unlock and disconnect engine coolant sensor wiring harnessĬonnector (Picture I, 2) from engine coolant temperature sensor Remedy: In case of customer complaint, extend wiring harness andĪdditionally an improved software will be available inģ. Gliwice: Zafira: W0L0AHM75AG060315 Astra H: Production in the production plants as of the following VIN's:Īntwerp: W0L0AH元5A5042356 Bochum: W0L0AHL48A2074366 Ellesmere Sensor too short/incorrect routed and contamination of plugĪn improved software has been implemeted in Wiring harness of engine coolant temperature Engine Z16XER, Coolant Temperatur Sensor -Ĭustomer complain about SVS on, trouble code
0 kommentar(er)
